+Article 43 Conformity assessment
|
Article 43 Conformity assessment
Article 43
1. For high-risk AI systems listed in point 1 of Annex III, where, in demonstrating the compliance of a high-risk AI system with the requirements set out in Section 2, the provider has applied harmonised standards referred to in Article 40, or, where applicable, common specifications referred to in Article 41, the provider shall opt for one of the following conformity assessment procedures based on:
|
(a)
|
the internal control referred to in Annex VI; or
|
|
(b)
|
the assessment of the quality management system and the assessment of the technical documentation, with the involvement of a notified body, referred to in Annex VII.
|
In demonstrating the compliance of a high-risk AI system with the requirements set out in Section 2, the provider shall follow the conformity assessment procedure set out in Annex VII where:
|
(a)
|
harmonised standards referred to in Article 40 do not exist, and common specifications referred to in Article 41 are not available;
|
|
(b)
|
the provider has not applied, or has applied only part of, the harmonised standard;
|
|
(c)
|
the common specifications referred to in point (a) exist, but the provider has not applied them;
|
|
(d)
|
one or more of the harmonised standards referred to in point (a) has been published with a restriction, and only on the part of the standard that was restricted.
|
For the purposes of the conformity assessment procedure referred to in Annex VII, the provider may choose any of the notified bodies. However, where the high-risk AI system is intended to be put into service by law enforcement, immigration or asylum authorities or by Union institutions, bodies, offices or agencies, the market surveillance authority referred to in Article 74(8) or (9), as applicable, shall act as a notified body.
2. For high-risk AI systems referred to in points 2 to 8 of Annex III, providers shall follow the conformity assessment procedure based on internal control as referred to in Annex VI, which does not provide for the involvement of a notified body.
3. For high-risk AI systems covered by the Union harmonisation legislation listed in Section A of Annex I, the provider shall follow the relevant conformity assessment procedure as required under those legal acts. The requirements set out in Section 2 of this Chapter shall apply to those high-risk AI systems and shall be part of that assessment. Points 4.3., 4.4., 4.5. and the fifth paragraph of point 4.6 of Annex VII shall also apply.
For the purposes of that assessment, notified bodies which have been notified under those legal acts shall be entitled to control the conformity of the high-risk AI systems with the requirements set out in Section 2, provided that the compliance of those notified bodies with requirements laid down in Article 31(4), (5), (10) and (11) has been assessed in the context of the notification procedure under those legal acts.
Where a legal act listed in Section A of Annex I enables the product manufacturer to opt out from a third-party conformity assessment, provided that that manufacturer has applied all harmonised standards covering all the relevant requirements, that manufacturer may use that option only if it has also applied harmonised standards or, where applicable, common specifications referred to in Article 41, covering all requirements set out in Section 2 of this Chapter.
4. High-risk AI systems that have already been subject to a conformity assessment procedure shall undergo a new conformity assessment procedure in the event of a substantial modification, regardless of whether the modified system is intended to be further distributed or continues to be used by the current deployer.
For high-risk AI systems that continue to learn after being placed on the market or put into service, changes to the high-risk AI system and its performance that have been pre-determined by the provider at the moment of the initial conformity assessment and are part of the information contained in the technical documentation referred to in point 2(f) of Annex IV, shall not constitute a substantial modification.
5. The Commission is empowered to adopt delegated acts in accordance with Article 97 in order to amend Annexes VI and VII by updating them in light of technical progress.
6. The Commission is empowered to adopt delegated acts in accordance with Article 97 in order to amend paragraphs 1 and 2 of this Article in order to subject high-risk AI systems referred to in points 2 to 8 of Annex III to the conformity assessment procedure referred to in Annex VII or parts thereof. The Commission shall adopt such delegated acts taking into account the effectiveness of the conformity assessment procedure based on internal control referred to in Annex VI in preventing or minimising the risks to health and safety and protection of fundamental rights posed by such systems, as well as the availability of adequate capacities and resources among notified bodies.
1. Übersicht
1.1 Referenzen
1.2 Identifizierte Anforderungen
1.3 Related Standards
2. Identifizierte Anforderungen
Anforderungen
| Source |
Anforderung |
3. Related Standards
Standards
| Source |
Anforderung |
|
SCF
|
Conformity Assessment
Description
Mechanisms exist to conduct assessments to demonstrate security, compliance and/or resilience capability conformity with applicable cybersecurity and data protection laws, regulations and/or contractual obligations.
Possible Solutions & Considerations
Micro-Small Business (<10 staff) / BLS Firm Size Classes 1-2
∙ Document applicable regulatory requirements in a checklist
Small Business (10-49 staff) / BLS Firm Size Classes 3-4
∙ Compliance checklist
∙ Annual compliance review
Medium Business (50-249 staff) / BLS Firm Size Classes 5-6
∙ Compliance management program
∙ Regulatory mapping
∙ Compliance calendar
Large Business (250-999 staff) / BLS Firm Size Classes 7-8
∙ GRC solution (e.g., SCFConnect, Cyturus, SureCloud, SimpleRisk, Ignyte, ZenGRC, Galvanize, MetricStream, Archer, etc.)
∙ Compliance team
Enterprise (> 1,000 staff) / BLS Firm Size Class 9
∙ GRC solution (e.g., SCFConnect, Cyturus, SureCloud, SimpleRisk, Ignyte, ZenGRC, Galvanize, MetricStream, Archer, etc.)
∙ Dedicated compliance team
∙ Automated compliance monitoring
SCR-CMM
Level 0 Not Performed
Practices are non-existent, based on the inability to demonstrate an implemented and operational capability. A reasonable person would conclude the control is not being performed.
Level 1 Performed Informally
SCR-CMM Level 1 criteria definitions are not available for this control:
▪ A reasonable person would conclude this control requires a structured process.
▪ At this level of maturity, the "ad hoc" nature of performing a capability informally would indicate the intent of the control is not met due to a lack of consistency and formality.
Level 2 Planned Tracked
Compliance (CPL) capabilities are requirements-driven, but are not standardized across the entity (e.g., local/regional level consistency). Capability criteria associated with this control reasonably expect the following criteria to exist:
▪ Policies and standards associated with CPL domain capabilities are formally documented and centrally-managed by the entity.
▪ Standardized Operating Procedures (SOP) associated with CPL domain capabilities are documented and maintained by process owners.
▪ IT and/or cybersecurity personnel work with business stakeholders and process owners to appropriately scope and reasonably implement cybersecurity and data protection controls associated with CPL domain capabilities to address applicable statutory, regulatory and/or contractual requirements for Technology Assets, Applications, Services and/or Data (TAASD).
▪ Compliance management controls-related controls are primarily administrative and preventative in nature (e.g., policies, standards, procedures & guidelines).
▪ Compliance management may be a defined function (e.g., team or department) or assigned as an additional duty to existing IT and/or cybersecurity personnel.
▪ External compliance requirements for cybersecurity and data privacy are identified and documented, based on applicable laws, regulations and contractual obligations.
▪ IT and/or cybersecurity personnel work with business stakeholders and process owners to assigned cybersecurity and/or data protection controls to comply with specific compliance requirements.
Level 3 Well Defined
Compliance (CPL) capabilities are standardized across the entity for applicability to People, Processes, Technologies, Data and/or Facilities (PPTDF) to ensure consistency for Technology Assets, Applications, Services and/or Data (TAASD). Capability criteria associated with this control reasonably expect the following criteria to exist:
▪ Policies and standards associated with CPL domain capabilities are formally documented and centrally-managed by the entity's Governance, Risk & Compliance (GRC) team, or similar function.
▪ Standardized Operating Procedures (SOP) associated with CPL domain capabilities are well-documented and kept current by process owners.
▪ A Governance, Risk & Compliance (GRC) team, or similar function, is appropriately staffed and supported to implement and maintain CPL domain capabilities.
▪ Technology is leveraged to enhance the efficiency and accuracy of governance, risk management and compliance operations (e.g., GRC platform).
▪ The entity's Governance, Risk & Compliance (GRC) team, or similar function, works with business stakeholders and process owners to appropriately scope and reasonably implement cybersecurity and data protection controls associated with CPL domain capabilities to address Minimum Compliance Requirements (MCR) (e.g., applicable statutory, regulatory and/or contractual requirements) and Discretionary Security Requirements (DSR) (e.g., entity-required controls).
▪ An implemented and operational capability exists to conduct assessments to demonstrate security, compliance and/or resilience capability conformity with applicable cybersecurity and data protection laws, regulations and/or contractual obligations.
Level 4 Quantitatively Controlled
Utilize SCR-CMM Level 3 criteria definitions:
▪ There are no defined Level 4 criteria, since it is reasonable to assume a quantitatively-controlled process is not necessary to operationalize this control.
▪ While it may be possible to develop “metrics-driven” capabilities for this control, the criteria would be organization-specific to define.
Level 5 Continuously Improving
Utilize SCR-CMM Level 3 or Level 4 (if available) criteria definitions:
▪ There are no defined Level 5 criteria, since it is reasonable to assume a continuously-improving process is not necessary to operationalize this control.
▪ Level 5 capabilities should be considered “world-class” where the control builds on Level 4 capabilities, but are continuously improving through Artificial Intelligence (AI) and/or Machine Learning (ML) technologies.
▪ While it may be possible to develop responsive capabilities for this control through the use of AI and/or ML technologies, the criteria would be organization-specific to define.
|
|